Answer Posted / kj

In theory the frequency and voltage should match exactly.
In practice the incoming generator voltage and frequency
should be slightly hogher than the grid.

This is to prevent the set from tripping on reverse power
or kva. The incoming generator will pick up some load
straight away so the frequncy and voltage matches the grid.

How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?

4114

---

H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....

1946

---

In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?

2036

---

transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?

2147

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

2022

---

Leakage current,un balance current which relay using for high voltage transmission?

2210

---

How many types of losses occur in a transformer?

1211

---

What is center gravity load in substation?

2477

---

transformer phasor diagram under load explain it?

2248

---

what parameters should we check to reduce the power bill

2381

---

is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details

2054

---

STATE WORKING OF VACCUM CIRCUIT BRAKER?

1980

---

WHY IL=IPH IN STAR AND WHY IPH=IL/1.732 IN DELTA? WHAT IS REASON BEHIND IT?

6460

---

what are all the components required to assemble solar panel other than pv cell?

1566

---

WHY RATING OF VCB NOT LESS THAN 630A

2675

---