if we open the inlet of an air regulator ,how it will affect
the out put of regulator? (out put of regulator is using to
operate an on-off valve.it is an air to open valve,and valve
is in open position.my doubt is air regulator will hold the
valve in open or not,if there is no consumption or leak in
regulator out put side ,we only loose the input pressure.)
Answer Posted / sandeep modi
If you open the inlet of air regulator,no pressure will hold
at air regulator,the pressure will go to zero and your air
to open valve will close.
But when you stop the supply of inlet air(not open the
supply) the pressure of AFR will be hold at that
condition,and if you valve is in open condition ,it will
remain open.
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
what are the selections available in configuring a burnout protection of a controller? thanks
How to calculate mmwc values into tonnes?
what is interface level measurement.who can calibrate interface level measurement transmitter online
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
Draw bode plot of any transfer function. Why is plotting bode necessary?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
What are different types of orifice plates? State their uses.
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
Explain plc level and its type?
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
what is scale factor of proximitor & unit of the vibration.