Interested to Buy Any Domain ? << Click Here >> for more details...
How to work DCS? how to get the signal from Field
Instruemtns to PIB to Console?
- 2 Answers
- 11537 Views
- Alstom, Invensys, I also Faced
- E-Mail Answers
Answer Posted / unlucky
DCS operates with HIS connected with FCS through controlled
communication bus
dcs generally receives signal from transmitters(field device)
and with the help of this and engineering station it will make
any control action they are connected through ethernet and
vnert cables
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Pl send the model question paper of mahagenco account officer post
Identification of control valve parts.
if my flow is 20000 m3/h than which range of DPT i have to use????
How oil line flow measured?eplain about instruments used and working principle?
Operational amplifiers
which type of zones used for boiler? & why ?
What is the purpose of LO Overhead tank in turbines.
Why not come out analog output in ABB EL3020 when display show correct value
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
how u choose thermowell lenght n pnumatic C/v size?
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
