Answer Posted / sara
That depends on type of flow meter that has to be calibrated . Will let you how a flow meter in lab is calibrated . Set up requires and piping arrangement test meter in line with a master flow meter ( ex turbine flow meter). And a prover is connected to that master meter. Basically test meter reading is compared with the master meter , error value is determined.
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
how can use ram
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
What is the purpose of bypass valve across AS valve.
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
why fuse block is not used for AI signal?
what is zero and span ?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
What are different types of cable?
Please can anybody help for control valve sizing step by step procedure?
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
