For an 100kw generator, only 50kw of load is connected. Will
the generator generate only 50kw or 100kw. If it generate
100kw what happens to rest of the 50kw. What happens if we
connect more than 100kw of load?
- 2 Answers
- 5523 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / balwinder
Any capacity Generator will not generate full power at all
times, According to load requirements it will give power. For
50kW load the 100kW generator will generate 50kW only.
There is no problem if we connect more than rated power in
small amount but it cause over heating of generator.
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
what is the difference between the voltage of 5 volts capacitor and and 5volts battery?
description with working of all parts of a Diesel generator???????
who can measure the size of power cable?
If any cable burnt how can we identify it burnt by high current of high voltage?
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
how to modify DOL control panel into Delta Y connection?
What is difference between isolator and circuit breaker?
What is hipot test procedure?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
What is FTA card? How it works?
explain the mode of metal iranafer in Co,welding
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
how we can calculate power factor in single phase & three phase ?thank u
When color of silica gel will gets change from blue to pink from Top to bottom?
