Interested to Buy Any Domain ? << Click Here >> for more details...
if we open the inlet of an air regulator ,how it will affect
the out put of regulator? (out put of regulator is using to
operate an on-off valve.it is an air to open valve,and valve
is in open position.my doubt is air regulator will hold the
valve in open or not,if there is no consumption or leak in
regulator out put side ,we only loose the input pressure.)
- 4 Answers
- 7212 Views
- Asian Paints, I also Faced
- E-Mail Answers
Answer Posted / mallu byali
AFR DOES NOT HOLD THE PRESSURE, IT IS ONLY REGULATE THE
PRESSURE AS YOUR DESIRED SET POINT OR WE HAVE TO SET THE
PRESSURE FOR OPERATING THE VALVE DEPENDS UPON ITS ACTUATOR
CAPACITY..
| Is This Answer Correct ? | 6 Yes | 5 No |
Post New Answer View All Answers
what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.
Any one can help me to identified, how can we interchange the device in FF
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
Galvanizing.
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
typical loop drawing of a simple feedback control comprising of one transmitter and one control
all types of liquid analyzer principle with drawing?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
Describe the functions of the Operator Interface including the considerations related to alarming and display layout/configuration/layers.
detail of mass flow meter pricipal
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
what is your eligibility criteria for freashers?
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
