Interested to Buy Any Domain ? << Click Here >> for more details...
what is the proportion of M25 geade cincrete.?
- 16 Answers
- 24431 Views
- Adani, L&T, I also Faced
- E-Mail Answers
Answer Posted / ashis malakar
M25 =1:1:2{cement :sand:aggregate:}
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
What is bmc stands for in bmc software?
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
how statics is different from dynamics
Dear Sir I Mahesh C. Bhamre have already given a Exam for Superintendent Officer / Public relation Officer Exam Dharmday Aaukta held at Nashik on Date 29/08/2010. My seat no was 5040247. and my cell no is 9822677994. and my mail Id is - mahesh.bhamre@rediffmail.com So can you pl send me details of result of respective exams. Thanking you in Anticipation.
04. a. Slenderness ratio…………… 1 b. If the height of a stage is 15-0 & dia. of the prop is 5, the slenderness ratio is….… 1 c. If the height of a stage is 10-0 & dia of prop is 3, the number of bracing will be…… 1
Which architectural movement is also known as jazz moderna?
How to find the cuplock pipe qty in staging for Minor bridge?
The 4 main factors to start a construction project are––
how to determine the correctness of proportion used in cement mortor and various IS codes to determine the same?
in a building why we are using T beams? why can i adopt beam bottom & Top level as same as slab bottom & Top level?
What is the Roll of Water Bonding under VDF road?
While calculating the weight of the steel per running meter, the formula used is [(dxd)/162]. Why 162 is used in denominator & how it is derived?
why we create short columns under grade slab?
HOE TO YOU PLAN TO ACCHIEVE THE GOALS?
