what will happen if the connections of protection ct reverse?
will it burn the ct?
- 2 Answers
- 3637 Views
- I also Faced
- E-Mail Answers
Answer Posted / sheikh
in case of reverse connection CT will not burn . however connected equipment may goes to malfunction or dead condition. as per example if Ct connected to kw meter and connection made inverse then kw meter given reading in Minus
like -245,-500kw . an other if ct work with any protection device like on reverse power relay in gen set and connection made in reverse then gen set goes on reverse power shutdown.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is ps impedance test
A power transformer 4MVA/11KV/0.415Kv has been out of use in 12years. what maintenance actions/test need to be carried out before energizing.
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
my diploma certificate in my higher education college
What is the dependency of stiffness on load angle??
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
what is auto re-closer?
if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value
how a flip flop can be used as a latch?
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
What is the unit of attenuation?
why the active power flow of some line is increased when the active power of out is cut ?
why ht cable end termination don't have a gland?
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
