During a temperature rise test of a bus duct, it is fed
with 415 volts at 2000 amperes. Why dont we get an electric
shock if we touch the bus bars?
Answer Posted / jivan gangawane
Generally this test is carried-out to verify the temp limits.
The testing done by applying low voltage to one end and
other end is shorted by suitable link same as that of heat
run test we conduct on transformers.
the capacity of test transformer is limited. Primary voltage
is high but the voltage on the secondary is less to a few
volts to circulate SC current.
So due to low voltage of the source, cuurent thru your body
will not flow due to low voltage.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why the check zone and main zone are used for Busbar Protn. scheem?
What is distance between electrical panel to land ?
how load of a turbo generator can be increased
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
state working of halogen lamp?
working principle of AC Servo Motor with its construction
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
the problem faced on star or delta winding connection??
different aspects of voltage stability
wheather the size of windings in motor and generator are the same
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
what is the total power generation in india?
What’s electric traction?