What is actuator what is motorized control valve?
Answer Posted / chandru
Actuator is a final control element in general in process loop.
Some of the type of actuators are
1. SOV Solenoid Operating Valve
2. MOV Moterised Operating Valve
MOV works with a limit switch mechanism , Helps the valve to OPEN/CLOSE via Gear box in front & Reverse rotation of motor.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
i want to find out iffco get test paper
How d.p. Transmitter can be applied to close tank?
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
What is the basic difference between Modbus and CAN Open Protocols
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
What is frequency factor in massflow meter? When using frequency output?
What are the interlocks we have to check during the start up of LP/HP compressor?
please tel me the calibration of pneumatic controler.
what does it mean an active front end in vfd plz explain it briefly
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
protection relay watchdog contact operation?
what are the different types of Protocols? & their applications.
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?