Interested to Buy Any Domain ? << Click Here >> for more details...
What is actuator what is motorized control valve?
- 5 Answers
- 13542 Views
- Emco, I also Faced
- E-Mail Answers
Answer Posted / bhogendra kumar
Actuator is a electronic device controlled via Analog output signal.
and Motorized valve are operate the maniacal equipment its just like a motor need to connect any valve just like oil,water,gas and extra.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
how works encoder in plc
how to control pid
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
what is metal of piston ring
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
What is voltage regulator?
what is diffrance between FF & SMART, explain with difination
selection of the zener barrier for the hazardeous area zone 0
what is the input to be given in digital flow meter during the the calibration time?
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
Which topics are covered in Process Control?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Why are the uses 24vdc in industries
it is possible to check the fail safe condition in pressure transmitter. if possible how?
what is the procedure of O2 sensor(ABB) calibration?
