Answer Posted / kofibahari

We assume this is a 6 leads out untagged. First we will get
the the continuity of each leads by using a multimeter.
Assuming we have done the continuity test, by then we can
get three pairs with continuity. Having this three pairs we
cannot really tell that our phase is right, so for us to run
the motor in the exact phase, we will get the right phase.
First we marked the first pair as U1 & U2 as our reference,
leaving the two pairs untagged. We then get one pair of the
untagged and connect one end to U2. We will supply U1 & U2
with a voltage lower than the rated voltage of the motor,
ex. if the rated voltage of the motor is 440V then we will
supply it with 220V or lower. We now measure the voltage
from U1 and the other end of the untagged pair not connected
to U2. If the voltage is more than the supply voltage then
the phase is right if not reverse the connection then put
marking V1 & V2. Do this procedure for the remaining
untagged pair. Assuming we already done our phasing we test
run the motor with a lower voltage again to avoid burning
the motor and measure if the currents in each phase are the
same.

what is high and low cut off voltage of BB and DG at SPS????????

1414

---

what is the voltage between earth to neutral in lift.

1754

---

sir pls send the je exam - 2008 and other model question papers..

2012

---

What do you mean by phasors?

1019

---

How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?

1403

---

What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.

1943

---

How many types of electrical earthing are there?

1096

---

What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?

2229

---

We have given to 3phase supply to ups system & how can coming netural

2096

---

What is shutdown of electrical sub station?

2441

---

write down the formula of cable size in RM if current is 50Amp.

1286

---

I WANT HOW CALCULATE TO CABLE FOR WELDING PLANT ?

1791

---

The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s

2792

---

what is the calculation formula for motor starting torque,running torque, running torque.

1632

---

if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required

2422

---