Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT HAPPEN IF TRANSFORMER HAS GIVEN SQUARE WAVE SUPPLY
- 3 Answers
- 7109 Views
- APTransco, NTPC, I also Faced
- E-Mail Answers
Answer Posted / raja
Assume we give square wave of 50 hz supply to txmr .
from 0 to postive maximum and then it will remain in maximum
value and same for negative axis also . since the rate of
rise from 0 to max + value / _value occurs at one instant of
time and not gradual . there will be no emf at secondary
terminals .
E = 4.44f*flux*turns*sinwt ( w =2pi* freq)- instantaneous
value of secondary emf .
| Is This Answer Correct ? | 8 Yes | 6 No |
Post New Answer View All Answers
What is distance between electrical panel to land ?
In CTs tan delta point should be earthed , what is the reason behind it?
induction 3 phase motor terminal connection
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
how to calculate energy of 3-phase motor?
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
why i can not use thimble on capacitor duty contactor
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
how maney type tempereture measurement ?
What are dcs and plc?
Hi Everyone ! My Name is Hakim ullah khan please i need formula of Cable Rating because i want to calculate by self without check any Table Chart... Thank you.....
