Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between LT and HT power supply?
- 26 Answers
- 187495 Views
- Center One Mall, Central University, JSW, Siemens, Suzlon, I also Faced
- E-Mail Answers
Answer Posted / yunus pinjari
Electrical power is generated in DC and while transfer this
power to customer/ user from generating station to ultimate
user the voltage get highly drop down, therefore it is
converted in to Alternating current ( AC) and then transfer
from generating station to ultimate user in distance while
the voltage get drops down we use transformers for stepping
up the voltage suitable . Therefore while transfer energy it
is High voltage ( i.e. HT ) and distributing to user this
high voltage is stepped down to suitable Low Voltage (i.e.LT
) e.g. 110v, 240v, 440v.
Differance...
HT lines LT lines
1)used for distribution
1)Use for transmitting to user.
energy from one point
to other .
2) Transformer requires to 2)no transformer require
maintainvoltage
3)Due to high voltage 3) Suitable voltage for
no user can consume energy user requirement
directly
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
What was your role in the silicon evaluation/product ramp? What tools did you use?
how much allowable resistance that can be difference in motor all coils?
What is the Current equation in series RLC circuits.
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
How much ph is maintained of water resistance starter for slipring induction motor ?
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
why the NGR (neutral grounding resistor) always OFF during DG off?
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
Why wind turbines wheels rotate constantly
what the principle of sincroscope?how it works?when it needed?
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
why we can use 1 to 5V dc
On Which Pressure PRV is operated.
