Answer Posted / muhammad imran jalal
The function of IGBT in VFDs is to chopp the DC voltage in
relation to original sine wave entering in the rectifier
section of the VFD. the switching speed of IGBTs is very
high as compared to Bipolar Transistors. Energy is saved in
VFDs by Affinity laws.
Imran Jalal
Electrical Engineer
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
lenz law application and define
why on delay timer used for fully automatic star delta starter?
How to decide and select the different earthing wire size for the different types of earthing
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
What does bode plots shows?
distribution is maximum done by a)radial b)network c) parallel d)b & c
How to find ampere on ht side for selection of cable size ???
Why arc quenching is used in Diode ?
What is different type of Electrical curve and how it protects the equipment's while up-normal situation?
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
why we cannot protect 100% winding of an alternator by using differential protection?
what are the interview question asked in wind mill about electrical
is it possible to test of bus bar in high rise building without completed full floor ?
how to calculation increase power factor for single phase