Interested to Buy Any Domain ? << Click Here >> for more details...
50 electric bulbs are connected across supply of 220 volts.
After one bulb is fused remaining 49 bulbs are again
connected to same supply. which case will have more
illumination & WHY????????
- 5 Answers
- 8686 Views
- KJ, I also Faced
- E-Mail Answers
Answer Posted / deepak thakur
(1st case 220/50=4.40volt) & (2nd case220/49=4.48volt)
so well have gets more illumination in the 2nd case
bcoz each lamp have more voltage in this case
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
How to Calculate The sag of OPGW in Transmission Line???
IN electrical field, WHAT ALL THINGS THE CUSTOMER WILL ASK WHILE ORDERING FOR LT PANEL (ALL TYPES OF LOW TENSION PANEL)
Why efficiency in thermal power plant is low?
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
What is difference between mcb and mccb.
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
Tell me all plants load factors i.e which plant operating on which load?
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
Explain bypass capacitor?
