Interested to Buy Any Domain ? << Click Here >> for more details...
why using earth testing rod 15 meter 30 meter long to each
other?
- 1 Answers
- 3548 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
1 : 2 ratio is to be maintained .You can go in for 30 and 60
and that will be more accurate
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
where is core-type and shell-type construction suitable for transformers ?
What are the material used for inductance coil?
How does HT work & Voltage required?
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
what is the function of impulse relay
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
While testing LA mast,What are the parameter limits ?
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
What happens if we run alternator on under frequency?
Can any body tell gulf interview question for experienced electrical engineer ?
how to calculate the lightning arrester conductor @ no of earth pits required
