Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / parthi
The starter is used to
limit the starting
current of the motor.
The starting time motor
takes high current(5 to
6 times of its rated
current). This high
current damage the
motor windings. So the
starter is essential for
motor.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
how mass curve differs from hydrograph.
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
what are the things that can cause a three phase motor to crawl?
What is the settings of distance protection relay in 400 kv line
What are the material used for resistor?
what material is the electrical housing wire made of? is there any difference for the telephone lines?
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
write encoder 17 pins details? pin a;b+, pin b;w+,..pin s & t. what is the meaning of b+, w+? explain;
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
what is the basic need of domestic loads 1- voltage 2- current
What is Diff btw Fire Alarm & VESDA System???
How to calculate the value of earth capacitance in a transmission line.
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
