what is the basic difference between capacitor and condenser ?
- 17 Answers
- 49394 Views
- ABB, Essar, I also Faced
- E-Mail Answers
Answer Posted / ge power system engineer
It's same device but little difference.
Capacitor consider ideal state.
and condensor consider real state.
for example) capacitor have only capacitance but condensor
include wire resistance, wire inductance also plate linkage
current is express equvalent plate resitance.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
wat system call?
Efficient electrical earthing in hard rock area
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
WHAT IS THE FUNCTION OF SHORT CIRCUIT MAINTENANCE CT
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
how to size H.T & L.T Panel ?
what is consequences of neutral and earth connect?
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
What is transmittance?
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
Classify milling machines.
