Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bharatgohel5314
CBCT means Core Balance
Current Transformer and it
used for cable protection.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
if we run a 3 phase machine on two phase what will happend??? given answer with solid reason please
1. What is the exact formula for one weber? for example,(one ampere = one coulomb electron of electrons crossing a point of conductor at one second. i.e, 1A=1Q/1sec)
Can Anyone suggest the Standards (IEC or IS) for selecting copper current density?
What is quadrantal symmetry?
what will happen if synchronous machine rotor fed from single phase ac supply
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
What will be the diameter of pipe between conservation tank and transformer
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
How Can I calculate for the photometrics requirements for a street lighting? Data given are: 45 units of 6 meter light pole with 150 watts metal halide lamp, 220 volts and installed in a promenade area.
State the frequency for rc phase shift oscillator?
what is the range of maximum DOL and SDS can be use for pump and fan application
what is the function of bearing in dc mchine" and where it is placed
What do you mean by dependent and independent voltage sources?
can the measured percentage error during calibration of single phase energy meter be negative?
