Interested to Buy Any Domain ? << Click Here >> for more details...
Why do we use compressor in pumps for pumping water through
borewells? Submersible pump is enough then why do we go for
this method?
- 4 Answers
- 12436 Views
- I also Faced
- E-Mail Answers
Answer Posted / venkatesh
one more point is, when there is only a small quantity of
water in the bore well by adjusting the quantity of air
going in we can pump out the available water.
plus easy to repair the borewell pipe faults as no heavy
motor is hanging at the bottom.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why should a chain drive be used over a belt or rope driven drive?
what is line balancing
What is the difference between Over Molding and insert molding ?
To operate 4 ac of 2 tons how kva genatator need
Low water in boiler drum is unsafe because it may result in overheating of water tubes in furnace. Why it is unsafe to have high water condition in boiler drum ?
Explain how the cylinder lubrication on main engine is done?
difference between 1st angle and 3rd angle projection
how we calculate the induced air capacity of id fan of a boiler?
what are the main problems of solar electrical systems? to make quality control on, which parameters that need so?
What will happen if boiler backfires?
How the bearing numbers are allocated?
How much calorific value of heat is needed to heat 00c of
What is the maximum cylinder head temperature of a 1200 KW, 12 cylinders DG set
what is the difference in Gas Welding and Gas Cutting?? Second Question is for Huge Casting which method is used??
Explain the difference between an electric motor and an electric generator?
