Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the earth pit resistance value?
- 7 Answers
- 29010 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / koti
for Individual pit; no specific fig ( in general max of 5 ohm)by standards but grid should be less than 1 ohm.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
pre arcing time of ehv breaker
How to select HT/MV cable size ?
excitation limit of an excitor
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
what is the working process of over & under voltage relay.
what is the question paper model for section engineer in RRB
I need model question papers for RRB section engineer Chennai... Please send to my E-mail Id:- maitheerainbow@gmail.com
What is difference between Sample test and Routine test in safety standard?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
Write masons gain formula.
how to calculate the loss tangent of electrical cables
How to Make relay co ordination chart for a Electrical power distribution of a plant
how can motor both beasrings insulation resistance can be check?
