in our sub station why we step down firstly 33kv\11kv then
11kv to 430v. can we direct step down 33v to 430.v.
- 18 Answers
- 36520 Views
- Eaton, Siemens, I also Faced
- E-Mail Answers
Answer Posted / mandeep kumar
Yes it is possible to step down from33/.433kv But it can only depend upon the transformer turn ratio its ht turn will be in large nos than 11/.433kv.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
lenz law application and define
how to find the voltage's of a transmission line plzz help with pictures i am not able to understand
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
What are the electrical engineer roles and responsibilities in chemical plant?
I Want randstand placement papers
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
WHY THE COLOR OF OUTDOOR TRANSFORMER IS BLUE ONLY???
dg earth connect only in the amf panel or not why
What is the disadventage of gland earthing(power cable) if any. ?
what are the differant std sizes of cable trenches?
how is working bearing heater?
What difference between ref protection and differential protection ?
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
