Why we use mostly circular coil in transformer? not square or
rectangular type of coil.
Answer Posted / suri
The flux linkage is more in the circular coil. just imagine
yourself.
| Is This Answer Correct ? | 0 Yes | 7 No |
Post New Answer View All Answers
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
Why power factor should not be in leading (capacitive) mode of any load.
WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL CURRENT??
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
Is there any abbrevation for STUB in Stub bus protection
Describe the test procedure to determine the vector group
Can clean earth cable be considered as low current cable
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
what is the importance of earthing system on the generators big capacity and small?
State nyquist stability criterion.
A cotter joint is generally used to transmit
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
What is the different between digital phase converter and ordinary phase converter?