Interested to Buy Any Domain ? << Click Here >> for more details...
What is RTCC panel and why it is required
- 31 Answers
- 135205 Views
- RTCC, Tivoli Grand, I also Faced
- E-Mail Answers
Answer Posted / santhosh san
RTCC stands for "Remote Tap Changer Control". RTCC panel
is used to give operation command to OLTC(On Load Tap
Changer)of Power Transformer from remote end.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
draw the block diagram of fire alarm?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
derive DC RMS value for half wave rectifier?
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
On what basis the the size of Lightning arrester for buildings are selected ?
what is the difference between the voltage of 5 volts capacitor and and 5volts battery?
What is Surge Capacitor? Why it is require in Generator Circuit Breaker,inspite of surge arrester?
how we explain parallel paths armature winding?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
How to operate a ac chilar plant?
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
what is relay what is protection & contact multiplying relays where it is used function in brief
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
