Interested to Buy Any Domain ? << Click Here >> for more details...
How do you know when the battery is fully charged?
- 6 Answers
- 12946 Views
- ABB, Pricol, I also Faced
- E-Mail Answers
Answer Posted / engr. shomaz ul haq
Place a low value resistance and a fully discharged capacitor in series with each other to the battery. The capacitor will charge rapidly. Repeat this procedure again. The lowest time charging time will indicate that the battery is fully charged.
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
What is difference between Over Current & Earth Fault protection?
what is the safety points of vaccum circuit breaker.
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
What is the meaning of Insulation H for transformers????
What are the specifications for conducting earth leakage test as per IEC standard?
what is acceptance test in electrical engineering.
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
our industries ht line so power fluctation(once drop of power please rectify causes
Can we use shunt trip coil instead of trip coil with protection relay for protection?
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.
Why increase in current leads to increase in conductor temperature?
