Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE FUNCTION OF PULSE TRANSFORMER IN DC DRIVE
- 5 Answers
- 8808 Views
- I also Faced
- E-Mail Answers
Answer Posted / aniruddha
it will give impulse signal at secondary side
in pulse for constant state its o/p is o
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
I WANT BHEL PREVIOUS QUESTION
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
what are the analog quality input for protection function?what are minimum reqiments?
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
what are the possible reaons & remedies if resistance of NGR getting heat up
How to do stting of vl250 siemens MCCB
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
'documenˁ
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
What are the basic components of the feedback control system?
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
