Interested to Buy Any Domain ? << Click Here >> for more details...
Can We Apply DC POWER To Transformer????
And Why????
- 4 Answers
- 6483 Views
- I also Faced
- E-Mail Answers
Answer Posted / uma
When the transformer is used with dc excitation, flux rises to the point where magnetic saturation occurs, causing a large increase in magnetizing current & overheating of the transformer. therefore they operate in ac.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
What is a fuse? How does it work? What are materials used?
What is the basic rule for block diagram reduction technique?
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
state the disadvantages of carbon filament???
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
For high frequency application we use which transformer?
What is the function of auadag in a cro?
Difference between On Line capacitor and Station Type capacitor.
What are the different methodes for calculating the short circuit Current?
Why frame of the motor is specified?. If we mention KW and voltage level,automatically frame is decided or separately frame is compulsory to mention?.
what is the id1 & id2 setting in differential protection relay of CSPC?
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
how to design coil turns ?
Formulae for calculating the transmission line losses for different voltage levels
