Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between signal cable and ontrol
cable?
- 14 Answers
- 65804 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / d_real
Signal cable= usually shielded type to prevent the EMI effect and carries 4-20mA
0-10v
Control Cable= not shielded type and carries 230-VAC, 110VAC, 24 AC/DC
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
How u measure the massflow in orifice flow measurement techniques
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
Draw a group of instruments interlocked to a Pump & Motor?
why we are using drum level control valve air to close?
Why MUX JB's are using only Temperature Element in Fundation field bus?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
What are the type of bonnets in the control valves?
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
Draw symbols of the following :
Why not come out analog output in ABB EL3020 when display show correct value
