Answer Posted / pradyumna chdndra panda
Flux produced in field of DC series motor is less and armature current is slightd reduced at starting time because very low value of resistance is used in dc series stator and by study these relation and effects, we sure that there is no back emf produced in dc series motor that is why ....
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What are the different methodes for calculating the short circuit Current?
What is turn ratio of a transformer?
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
why ht cable end termination don't have a gland?
how we calculate the withstansing current capacity of wires&cables?
Explain bypass capacitor?
what is the circulate the diesel in DG in side pls tell parts name and picture with circulate the diesel
hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
What are two contours of nichols chart?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What is the main use of rotary phase converter ?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
