Interested to Buy Any Domain ? << Click Here >> for more details...
If we tell 60 sq.mm. 3-1/2 core cable,then what does it mean
?
1) Each core section in the whole cable is of 60 sq. mm.
2) The whole cable is of 60 sq. mm. which is sub-divided
into 3-1/2 core.
- 3 Answers
- 5722 Views
- Cura HealthCare, I also Faced
- E-Mail Answers
Answer Posted / binod
3cores are 60 sq.mm & 1/2 is less than 60 sq.mm this type
of specification is meant for cable size(3phase and one
neutral)
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
i want some interview related questions with their answers which can help for attend the interviews...
How To Convert Apparent Into Real Power Without Knowing Reactive Power?
Define active and passive network?
how u measure/calculate renge of capacitor,capacitor has no any rating tag.what is the theory of measure of capacitons.
What is star-delta transformer?
why ups rating in kva? and why ups are in parellel?.why isolation transformer is used in ups?
what is the solution for meger test failed the MV cable?
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
What are the basic properties of signal flow graph?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
What is MSL designation of a motor and same may be provided in details.
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?
