Interested to Buy Any Domain ? << Click Here >> for more details...
What is the maximum distance limit of 4-20mA and 0-10V DC
standard signal transmission ?
- 3 Answers
- 17803 Views
- BARC, ME, I also Faced
- E-Mail Answers
Answer Posted / jobby c johnson
Distance is not a limiting factor for current transmission(4-20mA) where as it is a limitation for voltage transmission. Because based on the resistance the signal seeing there will be a voltage drop. then the voltage signal available at the host end will not be same at the generating side. Based on the distance these deviation will be more.
| Is This Answer Correct ? | 20 Yes | 1 No |
Post New Answer View All Answers
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
How to Calibrate Vibration Probe (Axial, Redial) in field
How to Calibrate Coriolis Flow transmitter in field
what are the use of belew gear in general ??
List three types Level Gauges with their working principles
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
How to check vortex flow meter is in good condition while we do not having calibration setup?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
What is 3 element control system
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
what are the steps I have to deal with?
