Interested to Buy Any Domain ? << Click Here >> for more details...
why we use tapechanger in primary side of transformer
- 5 Answers
- 9915 Views
- Bhel, L&T, I also Faced
- E-Mail Answers
Answer Posted / bhabanipattanayak
In a transformer pri. Wdg. Is
always wound over sec. Wdg.
So it is not possible to
connect tap changer in sec.
Side. For this reason we use
tap changer in pri. Side.
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
What are the two segments of nyquist contour.
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
what is meant by vector group of a transformer? How can it be derived?
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
What is a slack bus?
what are the specifications we must look at to select a relay for any capacity motor?
difine electrical ballast in HPSVL
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.
why there using acb enclosure in big buildings
State the methods of improving power factor?
what is the question paper model for section engineer in RRB
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
how to check regenerative load in drived motor
