what is the role of frequency in electrical system
Answer Posted / sunil kumar sinha
In A.C. circuiy, the electrical sourse is defined by its
nos of phase, voltage level and frequency.
Same nos of phase, voltage level and frequency supply my be
synchronised and connected. If frequency does not match of
the given two phases, a circulating current will flow
between the same phase of two connecting power sourses and
will result in short ckt. which is not acceptable.
The induction is also dependent on frequency. High
frequency will have high impedence in the circuit for same
inductance of the coil and also behave in the same mannery
with capacitance circuit.
further, the induction only come into picture when there is
change in flux which is dependent on frequency.also in A.C
circuit, voltage is dependent on frequency.
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
Why are iron cores in transformers made laminated?
WHAT KIND OF LIGHTENING PROTECTION SCHEMS CAN BE ADOPTED FOR THE FLAT ROOF OF BIG DIMENSION.
Define closed loop control system.
hi plz send me reliance placement papers..i.e electrical technical papers that have been asked in reliance test.
how to select proper cable for ct wiring so that drop within the limit.
What is step signal?
What is “pu” in electrical engineering?
what is KA rating and how can we choose switchgears on applications
Which device is used for the source of emission of electrons in a crt?
what is positive , negative & zero equivalent system resistance
What are the difference between CT/PT operated Meter and RRAMR Meter for HT/LT application?
What is electrical grounding?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
How to calculate Number of Earthing Pits....???