two bulbs of 100w and 40w respectively connected in paralel
across a 230v supply.which bulb will glow bright and why?
Answer Posted / ahatesham
Obviously 100W bulb will glow brighter because voltage
across both bulbs are same but current flowing through 100W
bulb will be more compared to 40W and power of 100W bulb
will b more.
Is This Answer Correct ? | 18 Yes | 1 No |
Post New Answer View All Answers
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
If o/p power is doubled by how much does the sound increase
What is the selection process of breakers. Can any one please give a formulation on same?
WHAT IS DEGREE OF COMPOUNDING IN D.C MACHINE MEANS? HOW TO READ THE OPERATING CHART FOR ANY ELECTRICAL MACHINES?
Can we use a absolute encoder to show rpm of a motor ? what about the condition when power is off ? what is difference if a incremental one is used ?abanirout@gmail.com
What do you mean by lighting transformer?
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
Explain the advantages and disadvantages of thermal power plant?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
why dc is used in control circuits for MV & LV switchgeras instead of ac
How wire size can define in electrical wiring? What is the ratio?
orifice sizing how done, checking & selection