Supose we have one 220v A.C fan.if we provide 220v D.C what
will be happen?
Answer Posted / ziauddin
if 220v dc supply is given to 1-p fan of 220v then the emf produced is zero n there are no flux ploduced by the magnet n torque wich is used to rotate fan is also zero hence it leads to burning f winding
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is two point starter?
What is proportional controller?
The capacitive reactance of a capacitor of 1/(2(PI)) F at 10^3 H is
how 650 volts creates? where is use?
What is the RME and explain the full form and what is the RME work?
What is difference between insulating medium and fault current interruption medium in a switching device.
i want to model paper for section engg.
work of choke in florocent tube circuit ?
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
State any two nuclear power stations in India, with their generating capacity.
how we do Vector group ,magnetic balance and tap changer test in Transformer?
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM