Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pradyumna chandra panda
for smooth control and provide trip system....
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
why electronic instruments is more favorable than electrical?
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
what are the factors to be considered while design the breaker either HT or LT??
how many electricity poles are there and what are the names and their sizes.
what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
I am abt to give IOCL intrv.Plz sir guide me for IOCL intrvw (Electrical).Which subject to be consider. questions are generally asked from which subject.Plz help me out.
block diagram of 2 ups system connected in hot stand by mode?
What is BusBar integrity test and how it is conducted?
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
How to calculate Voltage regulation of 22 KV Over head Line.
What are high pass filter and low pass filter? and What are the flowmeter ?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
why constant voltage transformer should be start without load? and if started then what will happen?
how is the incoming cable size calculated for a given current rating of a panel??
