why can't we use 5-20mA standard or some other instead of 4-
20mA?
Answer Posted / naveed ahmad
due to linearity, we can't use 5-20ma because in case of 5-
20mA our 25%,50% and 75% 'll not linear.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
Gas equation
Name different parts of a pressure gauge.
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
can we copy the software from a transmitter using hht(hart 275) ?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
what is the reason while warning lamp is on while the engine is cranking?
how to relay switch sense the fault?
How to convert milliampares into flow??
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
what is effect of specific gravity in differential level transmitter , explain formula related with this .
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?