Interested to Buy Any Domain ? << Click Here >> for more details...
what is the working principle of vortex flowmeter
- 9 Answers
- 22771 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / ramesh
The operating principle of the vortex meter is based on the
fact that when a flow hits an obstruction (bluff body), it
separates and moves around the object to continue on down
stream. Vortex swirls separate from the object on
alternating sides at the contacting point with the object.
This shedding causes low pressure swirls on one side and
high pressure on the other side. The process is reversed
from one side to another and keeps on alternating. The two
swirl frequencies are 180 degrees out of phase to each
other. And the frequency of this shedding process is
proportional to the velocity of the flow.
By measuring the frequency of formation of the vortex on any
side of the bluff body, the flow rate can be obtained. The
fluid velocity is proportional to the vortex frequency and
the width of the bluff body.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
How addressable fire systems work? Pl. send details with architect.(Loop), also send details regarding Gas system. Pl. help me.Thanks
In which principles tx ,pressure gauge,Temp gauge,control valve works?
what is the responsibility of an instrument commissioning supervisor
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
Hi Friends , i need one urgent help , i am preparing for M.tech entrance examination , i need some obejective questions related to instrumentation field. where can i get those ? can anyone help me pls ?
What is limitation of the ht.of the displacer of a level trol?
Why are the uses 24vdc in industries
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
How ejector(or)evactor air pump is working in thermal power plant?
What is the use of each wire in three wire RTD
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
where proximity sensor installed on tank in loading arm application
What is the use of control cable?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
