Interested to Buy Any Domain ? << Click Here >> for more details...
Why the power factor of the alternator in power plant is kept .8 lagging. Can't we maintain it at 1.
- 3 Answers
- 7765 Views
- I also Faced
- E-Mail Answers
Answer Posted / sidharth
The pf is maintained at 0.8 because generator has to supply reactive power to the connected transmission line if pf is maintained at 1 then the distribution transformers would not be energized as it requires some reactive power for its core to produce magnetic flux.Also the due to line capacitance the receiving end voltages will get higher than the sending end voltages. For more reference consult reactive power control topic.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
In all analog voltmeters or ammeter showing some small size symbols. as well as a star and in star 2no. digit, resister symbol,and other. what is that's meaning ?
11000volt DG set carnt kaise banvay
On 400 amp factory load how kvarh capacitors provide
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
why u r living from presentaly working.
Mention the difference between Analogue and Digital circuit?
what's producer of XLPE cable laying in undergroung
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
What types of high speed CMOS circuits have you designed?
What is the size of a 60 watt and 80 watt tubelight?
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
can any tell me why slope 40% and 80% is calculated in differential protection?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
What is a commutator?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
