what is differance between PLC system and DCS system
Proggramming.
Give me answer.
Thanks.
Answer Posted / bhaveshsavaliya
As we define PLC as programmable logic control,it has some
limitation related to its features like limitation of its
input/outputs,No.of Analog/digital interface and many other
which are applicable for only one particular application.
While DCS is also a control used for same application as
PLC,but when it Comes to your applications,you must know
difference between this ,For Example Like mega Power plant
or big capacity Refinery,where multiple task where
controlling at same time, which could not possible via
PLC,but we have to make mass communication between such PLC
modules which controlling such different task and give
feedback to masters,this will then define as Distributed
control system and make a huge task possible without any
Complication,consumption and failure.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
for the steam temp 420dec de superated to 120deg how much of water required
What is psychomotor behavior?
What causes little rust pockets to pop through or off concrete cylinder blocks (home)?
What is the major difference between Normal control loop and Cascade control loop and when to use cascade control loop?
What is quality management system? Weather qms is suitable, adequate and effective or not? Is there any quality policy? Is there any quality objective? If yes, then what are they? How they are planning to achieve quality objectives? Do they are measure quality objectives?
Sir, we are manufacturer of splitter machine. we joint two knifes with welding electrode, BEST ARC, and ADOR, Grade E6013. but the time of welding the welded area comes to wear, what meterial(Electrode)is suitableto our requirement.this knife is press with Hydraulic operation.
plz send me l&t auestion papers. i have been called for written and interview industrial automation 2 yrs exper. send me on mail pal_deepak06@yahoo.com
What is setup time?
what is fixed bearing?
axial displacements of the turbine. What could be the causes?♪ ♪
What is autofacturing?
What is total quality control? Mention the technical standards.
We will import machihery. how we will take input
i have one air blow heater , coiled heater is in side hollow ceramic tube and passing the air and other end hot air is going out, to control the hot air where i should fix up a THERMOCOUPLE on the heater or on the out let of hot air terminal which is the best way
state the care that shall be taken while checking the diode