Interested to Buy Any Domain ? << Click Here >> for more details...
I have calculated load for an office building which is 1200
KW
as all the load is single phase therefore its 1200 kw single
phase. Now i have to design Transformer and Generator for
this load Please kindly give me exact answer that how much
capacity of Three Phase Transformer and Three Phase
Generator is required for this load.
- 3 Answers
- 6213 Views
- I also Faced
- E-Mail Answers
Answer Posted / mayadhar81
1200 kw = 1200*1000 watt
that means 1200000 watt ok
In single Phase for example 1000 watt load,supply 230
volts,current is watts/volts
answer is 1000/230=4.34 amps ok
in 1200000 watts =4.34*1200=5208 amps ok
Per phase current=5208/3=1736 amp
three phase transformer/ generator=1736/1.392=1247 kva dg
or transformer is used for full load.
Then you have used 1500 kva dg or transformer
and put it 80% load.
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
why the projects getting loss?
how to generator maintenance (A Check, B check,Etc)
Differentiate between low pass, high pass and band pass filter?
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
How to calculate Grid rotor resistance(GRR) losses in slip ring induction motor?
1hp= how much rpm
what is the difference between directional & non directional earth fault with example please explain.
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
Transmission through a short line depends on
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
what are types of encoder
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
