Interested to Buy Any Domain ? << Click Here >> for more details...
What happen if we have run 415 V,50Hz designed motor at on
480V,60HZ
- 8 Answers
- 21969 Views
- I also Faced
- E-Mail Answers
Answer Posted / engr. kashif
Increase in V will cause the insulation of the winding to become weaker with the passage of time and eventually may become short, thus damaging motor and possibly surrounding components.
Increase in frequency causes an increase in motor speed and that may well be harmful as the motor is not designed to run at the new increased speed. This will also cause increase in the motors winding inductance, decrease in the current being drawn, increase in power losses.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how to calculate current carring capacity of cable and cable selection? 1) copper flexible cable 2) copper armoured cable 3) Aluminium cable
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
where does 22kv line starts
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
Let me know that how i calculate the alternator sub tranciant reactance and tranciant reactance.
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
How to set the relay,,??
What happen Grid EARTH plat got cut.
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
what is the working principle of a DG Set, Alternator, & exiter
What is the difference between grid and off- grid system??
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
