Interested to Buy Any Domain ? << Click Here >> for more details...
fuses rated by amperes but not power,why?
- 3 Answers
- 6983 Views
- Blue Star, I also Faced
- E-Mail Answers
Answer Posted / doss
fuse is one of the protection for load .also we called fuse is low melting point.current only can make heat and melt the fuse. when the load side get any problem ,load going to take over current .so the over current flow through the fuse and melt the fuse and break the circuit.fuse selection is depends upon the load.its a simple protection.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
hai now i am working as a electrical design engineer in construction field can i get a job in oil and gass field or power plant project as a electrical design engineer?
what is mind in cable
can the measured percentage error during calibration of single phase energy meter be negative?
In HI POT test what is reason for applying the AC VOLTS and DC VOLTS in different applications what is the nessesity for this ?
Which type of motor is used in trains, what is the rating of supply used explain working principal?
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
pls,send the previous year written test questions.
Explain mechanical rotational system?
What is different type of Electrical curve and how it protects the equipment's while up-normal situation?
What is the formula to calculate the rating of a three phase miniature circuit breaker
why single CT used in DOL starter power circuit?
EXPLAIN THE TRANSFORMER MAINTENANCE?
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
