Answer Posted / sumit sahrma
i want to gave answer of kunal arora....about cc it is
calculated by bore size,stroke length.....ie
(.785*dia*dia*stroke length)
| Is This Answer Correct ? | 10 Yes | 9 No |
Post New Answer View All Answers
prove the relation for the torque required in order to accelerate a gered system?
Tell me the formula of heat loss in a pipe.
Why oil with petrol can be used in two stroke engines but not in four stroke engines (two wheelers)?
What are rolling bearings ?
Describe the stress and strain curve of steel.
The function of the final drive is to a) Provide a permanent speed reduction b) To turn the drive round through 90o c) To provide drive to the rear wheels d) all of the above
In a constant mesh gear box, when the right dog clutch is engaged with the gear on the right side of the main shaft, a) Direct gear is obtained b) First gear is obtained c) Second gear is obtained d) Reverse gear is obtained
The friction plate is always mounted on a) flywheel b) Pressure plate c) Internally splined hub d) Clutch spring
1) can any one tell how dozer transmission system power terrain --track
Define Poisson's ratio.
The crown wheel of the final drive is connected to a) Cage b) Spider c) Cross pin d) Axle half shaft
Define white metals.
What is the difference between bs2 & bs3 engine?
The Hook's joint works efficiently when the propeller shaft inclination is a) 18o b) 28o c) 38o d) 48o
What is a pneumatic system and where is it used?
