What is the effect if power factor is above 1 or unity.
Answer Posted / raviteja
power factor is nothing but phase difference of current
w.r.t voltage.power factor never exists beyond 1.since
cosine angle of phase difference ....thats why it in
between -1 to 1.....
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
difference between crane drive and line drive.
What are the disadvantages of thermal power plant?
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
why lightning arrestor are made in two stack of insulator but why not cvt
Difference between on line capacitor and Station type capacitor
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
what are the different methods for the starting of a synchronous motor.
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
1.what is the difference between ct and cvt? 2.what is the difference between pt and cvt? 3.what is the difference between relays and circuit breakers?
How you calculate the repturing capacity of a HRC fuse
what are the advantage and dis-advantage of 3 phase 4 wire energy meter?