Interested to Buy Any Domain ? << Click Here >> for more details...
i want use pressure transmitter for flow ,how?
- 5 Answers
- 10233 Views
- Gasco, I also Faced
- E-Mail Answers
Answer Posted / mokie
use differential pressure transmitter with oriface, vcone or
the other means
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
Please can anybody help for control valve sizing step by step procedure?
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
which type of zones used for boiler? & why ?
in mass flow meter what is drive friquancy ?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
Specific gravity.
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
How to measure the dust in chimney(spm)?
what is the calibration procedure for magnetic flow meter @ onsite
What are different types of orifice plates?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
Can I calibrate the Electromagnetic Flow Meter on line and How.
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
