Abb 11kv how it is closing automatically when the cb is racking in and rack out when it reaching test position
Answer Posted / hiltipower
when breaker in rack in position its limit switch closed
for only automatic operation when breaker rack out another
limit switch closed at rackout position so only manual
operation or test position operation possible
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is thresold of perception
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
Explain cos(theta) and Sin(theta)
what is the principle of operation of tungstun bulb ??
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
What is measurement?
What are the internal and external faults?
What is the difference between the impedance percent and impedance voltage ?
number of I/O devices in siemense plc
IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.
Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station
why impedance relay is used for medium transmission line protection
is it possible to have dc motors on single chip
hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.