Interested to Buy Any Domain ? << Click Here >> for more details...
what is ground clearence ,what is minimum ground clearence
,i.e present value following in india ,is it changes wit
conductor size ,kva rating.surface
- 3 Answers
- 8781 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Clearance depends on voltage only. For the minimum
clearances to be maintained, refer to IE rules 1956
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
How many types of colling system it trformers?
How the setting of the vector surge relay shall be calculated when the relay is to be used for Grid islanding application?
what are the principles of a booster converter?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
What is Phase margin?
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
What are the two types of compensation?
how are reversing the direction of rotation of dc motor
what is the difference between surge protection capacitor and surge arrestor
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
how to flameproof electrical motor on the shaft?
