Answer Posted / satya dev
Basically all the aroplanes are constructed with metal and
hard plastics. during the flying in the sky all the metlic
parts are charged due to air and cloudes it is called
static electricity. now it is not possible to make
paramanat erthing to the airoplane when its flying but to
avoid the mejor problem occured all the tyres of the
aroplanes are made with good conductor along with the
rubber. when aroplanes are landing all charged electrone
are immediatly connected to ground and it has earthed to
make safe the aroplanes.may be all of you know that the
runway is already made for switable earthing.
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
what is the difference between online & offline caliberation of KWH meters. Can Digital meters be caliberated
what is the eight bit unit?
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
What is the disadvantage in proportional controller?
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
Define filter?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
What is the general system requirement of alternator?
why we are not giving the zone 1 trip command to the master trip relay
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
when will be the iocl interview results ifaced the interview on september 8 th
what is differnce btwen lll and lllg faults